1. Enter Internal Component Clearance
Defaults to Inner Clearance mode so your PCB, sensor module, or collectible fits cleanly without manual wall-thickness arithmetic.
Pre-tuned for cast PMMA acrylic sheets with inner-clearance sizing, flame-polished joint kerf (0.16 mm), and distortion-free 1:1 mm SVG/DXF cut plans.
Defaults to Inner Clearance mode so your PCB, sensor module, or collectible fits cleanly without manual wall-thickness arithmetic.
Keep 0.16 mm for snug friction dry-fitting or drop to 0.14 mm when capillary-bonding edges with Weld-On #3 or Acrifix.
Toggle blue labels off for crystal-clear acrylic panels, then export 1:1 mm .SVG or .DXF directly to your CO2 laser.
| Laser Machine | Material & Thickness | Measured Kerf | Typical Speed / Power | Joint Fit Guidance |
|---|---|---|---|---|
| Glowforge Basic / Pro (40W CO2) | 3mm Baltic Birch Plywood | 0.15 mm | 170 / Full | Tight press-fit; no glue needed on small boxes |
| Glowforge Basic / Pro (40W CO2) | 3mm Cast Acrylic | 0.16 mm | 165 / Full | Use 0.14 mm for slip-fit solvent welding (Weld-On) |
| xTool S1 / D1 Pro (20W Diode) | 3mm Basswood / Birch | 0.12 mm | 8 mm/s · 100% | Fine rectangular diode spot; air assist mandatory |
| xTool P2 (55W CO2) | 4mm MDF / Draftboard | 0.18 mm | 16 mm/s · 90% | Wipe charred edges before dry-fitting finger joints |
| OMTech K40 / 60W CO2 | 6mm Baltic Plywood | 0.20 mm | 9 mm/s · 75% | Use 2-inch focal lens to minimize tapered kerf walls |
Always choose Cast Acrylic (cell-cast PMMA) over extruded acrylic for finger-joint enclosures. Cast acrylic vaporizes cleanly with glossy transparent cut edges and resists stress crazing when solvent cement wicks into tight interlocking finger tabs.
Leave the protective paper masking on both faces during cutting to eliminate vapor hazing, and double-check actual sheet caliper thickness (nominal "3 mm" acrylic often measures 2.85–3.15 mm) before generating your final DXF.
Cast acrylic sheet thickness varies by ±10% across batches (2.75 mm to 3.25 mm). Entering your exact caliper measurement ensures finger tabs sit perfectly flush with the outer case face.
Standard 450 nm blue diode lasers pass straight through transparent clear acrylic. Clear acrylic requires a 10.6 µm CO2 laser (Glowforge, xTool P2, OMTech), whereas diode lasers can cut opaque black or dark cast acrylic.
Uncheck Include Blue Engrave Panel Labels in the left parameter dock so your exported SVG contains pure red cut outlines only.